How to make an origami boat: a classic scheme with detailed analysis and photos

A classic layout of a flat ship

Make a simple origami boat out of paper for children can be using a single sheet of paper. To then let it float down the river or a small stream, it is sufficient to lubricate the edges with laundry soap or wax.

Instructions:

1. A rectangular piece of paper should be folded in half lengthwise. After that, crosswise, then return it to its original state.
2. The top edge of the sheet to turn to the middle part, repeat with the wrong side.
3. Necessary to carefully bend the corners inside the design.
4. In fact, you should get a kind of envelope, which in the final stage of turning inside out.

All movements should be smooth and accurate, since there is a chance to damage the corners of the structure. At the end, you need to slowly stretch the construction so that in the middle there is a sealed lozenge.

A simple ship can go free sailing. Adults can also remember the scheme of folding a cap from the newspaper, which as a child everyone did.

A boat with a sail for children

The scheme differs significantly from the classic version, but there is nothing complicated about it.

Detailed instructions:

1. For origami suitable square piece of paper.
2. It should be folded diagonally. Be sure to bend all 4 corners, to make a cross on the sheet.
3. All four corners are going to the central point.
4. Need to unfold the design.
5. Next, a square with folds turned over to the other side and fold in half.
6. Each half, which appeared during the instructions, folded again.
7. Next, the sheet is again unfolded on the front side.
8. Folded in half again.
9. Should appear guiding diagonals, which should be folded sides.
10. As a workpiece will be ready to fold the figure in half.
11. Free angle unbent, we get a full sail.

It is unlikely this design will hold water, but it can be a wonderful part of the decor. In addition, you can paint the composition with gouache.

The main thing is not to put the product on the radiator or near a heat source, because after drying it will lose its appearance.

How to make an exhibition ship of origami modules

Ship with raised sails reminiscent of the possible journey. This instruction is much more complicated than the previous ones, but if you have to participate in an exhibition or competition, it is definitely worth a try. Modular origami was invented in 1734, according to the source "Ranma Zushiki.

The technique allowed patience, attention to detail, so for a while even taught in school. Now it is to figure out how to make an origami boat from paper on an unusual technology.

How to make a module

The design will consist of 1027 modules, which can be fastened with ordinary glue. The main difficulty is that you need to make even and neat details, from this will depend on the appearance of the design.

Instructions:

1. You need to take a rectangular sheet, then divide it into 38 equal parts.
2. For convenience, you can print out the cells in advance on a printer, then cut them out with scissors.
3. Each part should be folded in half, then unfold.
4. Rectangle corners connect the middle.
5. Turn over and lift the edges up.
6. Bend the corners, you get the top of the ship described earlier.

Then the edges of the planned lines to unroll. Should get a figure with two pockets, they are involved in the connection. Thus, the master creates a modular constructor, from which you can assemble any craft.

How to assemble a modular ship

There are two options: the assembly is due to the imagination of the master, or apply ready-made schemes. To simplify the first assembly, it is better to use a ready-made instruction:

1. The ship is assembled in rows. In total, 16 lines will be used for the deck and 12 for the sail.
2. The first row is dialed 47 modules.
3. The base is made of 4 rows, where each add 1 module to the ring.
4. From rows 5 to 7, it is necessary to make the volume of the figure with 55 pcs.
5. From line 8, everything goes on the reduction of 1 pc. up to row 17.

So that the sail will not fall off the ship, you can glue a skewer. Then it is worth proceeding to the assembly. Here everything is simple, you need to count the remaining modules and collect the design on an identical scheme. The master can experiment with any coloring, create patterns during assembly. The process will resemble a game of "Lego".

How to make origami steamer

Origami steamer - another model that is easy to fold and requires a few simple steps. A brief instruction of origami boat from paper for children:

1. You need to start with a square piece of paper, painted on one side.
2. You need to fold the paper in half, and get the vertical and horizontal folds in the center.
3. Paper is turned over and made the bottom fold so that the end of the sheet coincided with the central fold.
4. Then the construction is turned over. The right side is lifted and placed against the central fold. After that, you need to press and smooth well.
5. Need to repeat the above step for the left side.
6. Lift the square at the bottom left and make a squash fold, for the right side as well.
7. Bring the top of the model to the bottom. Fold and make a fold.
8. Unfolding, you can see that the center is formed horizontal fold.
9. Now you need to make another fold so that the top coincided with the beginning of the bottom.
10. Make a small triangle in the form of folds on the edges.
11. Unfold these triangular folds and put the folds together.

The final step is the unfolding of the design, after which you get a steamer. Send it afloat by waxing the edges beforehand. To create a model is better to use colored paper in which the parties will be different shades.

Origami constructor of cardboard

This method is suitable for those who are only developing motor skills. Constructor is created on the basis of the scheme, which you can think up and draw yourself in paint or on paper. How to assemble:

1. There are several types where glue and special compartments are used to place the "clasps."
2. In both cases, each piece is cut out with scissors.

There are no rules in this master class, you can let your imagination run wild. If the work will be performed by a child, you need to ensure comfort and safety (plastic scissors and ruler are chosen).

Photo origami boat